Bostitch CRN38K Specifiche Scaricare il pdf (Pagina 6)

• For best operation hold the tool as you would a screwdriver or drill dri-

ver as shown.

• It is not necessary to push the tool hard, simply follow the nail down.

NOTE: Head damage and incomplete drives will result if the tool is

pushed hard.

• The tool will drive the nail quickly (less than .25 seconds). For opti-

mum battery life push the tool down quickly.

The operator must not hold the trigger pulled except during fastening operation,

as serious injury could result if the trip accidentally contacted someone or

something, causing the tool to cycle.

Keep hands and body away from the discharge area of the tool.

COLD WEATHER OPERATION:

For cold weather operation, near and below freezing, the tool may slow down in operation and battery capacity

will be reduced.

Do not store tools in a cold weather environment to prevent frost or ice formation on

the tools operating mechanisms that could cause tool failure.

ENERGY ADJUSTMENT/FASTENER DEPTH CONTROL

• Fastener drive depth adjustment is accomplished by rotating the

adjustment wheel of the Energy Management System.

• Rotate the wheel counterclockwise for deeper drives, clockwise for

less depth.

• Thicker layers of shingles generally require more depth of drive.

• Unless the shingles are hot the tool can typically be used at the

maximum setting without overdriving and damaging the shingles.

• To optimize the number of fasteners per charge, adjust the energy

management system so the driven nails are flush with the shingle sur-

face on the lowest setting possible.

TOOL OPERATION CHECK

Remove all fasteners from tool before performing tool operation check.

Contact Trip OPERATED TOOL:

With finger off the trigger, press the contact trip against the work surface.

THE TOOL MUST NOT CYCLE.

Hold the tool off the work surface, and pull the trigger.

THE TOOL MUST NOT CYCLE.

With the tool off the work surface, pull the trigger.

Press the contact trip against the work surface.

THE TOOL MUST TURN ON.

Without touching the trigger, press the contact trip against the work surface,

then pull the trigger.

THE TOOL MUST TURN ON.

THE TOOL WILL CYCLE EACH TIME THE TRIGGER IS PULLED!

-6-

Adjusting Wheel

1 2 3 4 5 6 7 8 9 10

Commenti su questo manuale

Nessun commento

Bostitch CRN38K Specifiche Pagina 6

Commenti su questo manuale

Prodotti e manuali riguardandi Attrezzi elettronici Bostitch CRN38K